Adding a Holding Tank
I added a holding tank to my 1980 Mk1 Griffon back in the winter of 1999/2000 but several owners have asked for details, so here you are.
Where to put the Holding Tank
There is not much room in the Griffon's heads but there is a suitable locker next door in the fore-cabin. The locker is an awkward shape, so I made a cardboard tank and adjusted it to fit, then created the drawing from which the tank was made. To save anyone else going through this, here is the drawing I created (please check that it will fit your Griffon, just in case....).
How to fit the Holding Tank
The holding tank was manufactured from plastic to my drawing by Tek-Tanks but it could equally well be made from stainless steel.
The only way that I could think of to fix the tank in position was to use spray builder's foam, which you can buy from B&Q etc. The tank is very securely held by the foam and is still held fast after 14 years. Inevitably you get excess foam but it is fairly easily trimmed with a carving knife once it has completely set.
Plumbing the Holding Tank
There are three pipes to the tank, the inlet, the outlet (which has an internal pickup pipe to the bottom of the tank) and the vent. The vent needs to be the same size as the other two and should have a swan-neck and a shell vent to stop water getting into it from outside.
