Difference between revisions of "Centaur Rudder bearings"
| Line 15: | Line 15: | ||
When refitting the tube take care to replace exactly as it was otherwise the hole in the rudder post may not reach high enough. Whilst you need to use sealant under the lower flange do not make it too thick. | When refitting the tube take care to replace exactly as it was otherwise the hole in the rudder post may not reach high enough. Whilst you need to use sealant under the lower flange do not make it too thick. | ||
| + | Also the hole in the collar may be off centre...try turning the collar round! | ||
Revision as of 08:32, 17 February 2019
New bearings are available from Trafalgar Yachts
Rudder Tube
The Centaur Rudder shaft is housed in a stainless steel tube.The tube is in two parts. The top part screws on to the main lower part of the tube which is fitted from below and bolted in place. The bolts are difficult to access and may require a an access panel/hatch cutting out.
There is a plywood shim at the top and the top part of the tube screws on and seats on this. The plywood is prone to water damage and may have to be replaced possibly with plastic.
When refitting the tube take care to replace exactly as it was otherwise the hole in the rudder post may not reach high enough. Whilst you need to use sealant under the lower flange do not make it too thick. Also the hole in the collar may be off centre...try turning the collar round!
