Difference between revisions of "DIY cockpit seating teak substitute"
(Created page with "The original teak boards were in excellent condition, but the fact is they were prone to leaks as they were bolted to the seating area. I removed these and will no doubt make som...") |
|||
Line 7: | Line 7: | ||
I followed the instructions on the Permateek website and this is the result. I used tow tubes of Sikaflex 291 white adhesive. | I followed the instructions on the Permateek website and this is the result. I used tow tubes of Sikaflex 291 white adhesive. | ||
− | Courtesy of Ken Hastie | + | Courtesy of Ken Hastie<br /> |
− | [http://www.hastie.org.uk/] | + | [http://www.hastie.org.uk/|www.hastie.org.uk] |
Revision as of 21:33, 13 April 2012
The original teak boards were in excellent condition, but the fact is they were prone to leaks as they were bolted to the seating area. I removed these and will no doubt make some pretty drinks holders out of them in due course. I considered getting Treadmaster but I heard they were difficult to keep clean and I didn't want a rubber look.
When I was down at the London Boat Show at Excel I chanced upon imitation teak and found three suppliers. The one that was most helpful was Permateek so I began an exchange of correspondence when I got back home to get a good price to justify any further expenditure on my Centaur.
I made my mind up to get Permateek for the seating area and the tops of the coaming. Cost me over £400 but it really does look very good. I made paper templates and sent them off to Ian 'Griff' Griffiths who made up the panels for me and sent them off within a couple of weeks.
I followed the instructions on the Permateek website and this is the result. I used tow tubes of Sikaflex 291 white adhesive.
Courtesy of Ken Hastie
[1]