Frozen Safety Rail Supports

This is a common problem which is usually due to the dissimilar metals eg supports are stainless and the bases are aluminium. All aluminium supports and bases will also corrode and freeze up. Ideally you should have both supports and bases as stainless. If your supports are not frozen look after them by removing them frequently and replacing them with a covering of grease or PTFE.

If you have frozen supports and you want to remove them say to make your winter cover sit flatter or if the bases are split proceed as follows:

First remove the supports from the boat.

This is not trivial because you will have to delve behind the side deck head lining and you will find that the bolts are glassed over.

The glass can be easily chopped away to expose the nut and washer which can then be removed. A neat way to expose the nuts is to use a small diameter hole saw with the drill replaced by a rod. When you have the supports and base removed you can either replace both with stainless or take them back to a workshop to try to separate your original parts. This is difficult but not impossible. Proceed as follows: Don't rush it. Sit the seized ends in pot of diesel or paraffin or release/penetrating oil for as long as you can. The parts must be completely submerged in the release fluid. Then support the base in a decent vice with the stanchion vertically down, not nipping it too tightly. Get a large drift just small enough to penetrate the hole in the base about 3/4 inch dia. and using a 4 pound hammer give it a good belting. I removed two of them last week with no damage to either part.

Don't forget to drift or drill the retaining bolt first.